Table of Contents
Advertisement
Back to Contents Page
System Fan and Heat Sink Assembly
Dell Studio One 19/1909 Service Manual
Removing the System Fan and Heat Sink Assembly
Replacing the System Fan and Heat Sink Assembly
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
Do not touch the fan when the computer is powered on.
CAUTION:
Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps
incorrectly could damage your system board. For technical service information, see the Setup Guide.
Removing the System Fan and Heat Sink Assembly
1. Follow the procedures in
Before You
2. Remove the computer cover (see
3. Remove the shield (see
Removing the
4. Remove the stand (see
Replacing the
5. Remove the back I/O panel (see
6. Remove the three screws securing the system fan to the system board.
CAUTION:
The heat sink assembly may be very hot during normal operation. Be sure that it has had sufficient time to cool before you touch it.
7. Loosen the two captive screws securing the heat sink to the system board.
8. Slide and lift the system fan away from the frame of the computer.
9. Disconnect the system fan cable from the connector (SYS_FAN1) on the system board.
Begin.
Removing the Computer
Cover).
Shield).
Stand).
Removing the Back I/O
Panel).
Hide quick links:
Advertisement
Table of Contents
