Removing Rimms - Dell OptiPlex GX300 User Manual

c. Press the RIMM straight into the slot running down the center of the socket until the securing tabs snap into place around the ends
of the RIMM.
Figure 2. Installing a RIMM
5. Rotate the power supply back into position, making sure that the securing tab snaps into place.
6. Replace the computer cover, and reconnect your computer and peripherals to their electrical outlets and turn them on.
NOTE: After you remove and replace the cover, the chassis intrusion detector causes the following message to appear on the
screen at the next system start-up:
ALERT! Cover was previously removed.
The system detects that the new memory does not match the existing system configuration information and generates the following
message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup utility
7. Press <F2> to enter System
The system should have already changed the value of System Memory to reflect the newly installed memory. Verify the new total. If it is
correct, skip to step 9.
8. If the memory total is incorrect, turn off and disconnect your computer and peripherals from their electrical outlets. Remove the computer
cover, rotate the power supply, and check the installed RIMMs to make sure that they are seated properly in their sockets. Then repeat
4, 5, 6, and 7.
9. Reset the chassis intrusion detector by
changing Chassis Intrusion
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting
the chassis intrusion detector.
10. When the System Memory total is correct, press <Esc> to exit System Setup.
11. Run the Dell Diagnostics

Removing RIMMs

To remove a RIMM, press the securing clips outward simultaneously until the RIMM disengages and pops out slightly from the socket (see Figure
3).
Figure 3. Removing a RIMM
Back to Contents Page
Setup, and check the value for
to Enabled or Enabled-Silent.
to verify that the RIMMs are operating properly.
System Memory.
1 Securing clips (2)
1 Securing clips (2)
2 Slot
steps