Dell OptiPlex GX300 User Manual page 57

Diskette drive 1 seek failure
Diskette read failure
Diskette subsystem reset failed
Diskette write protected
Drive not ready
Error! The previous boot failed to
complete. Last reported checkpoint was
nnnn.
Gate A20 failure
General failure
Hard disk configuration error
Hard disk controller failure
Hard disk failure
Hard-disk drive read failure
Incompatible Processors: Cache sizes
different!
Invalid configuration information - please
run SETUP program
Keyboard clock line failure
Keyboard controller failure
Keyboard data line failure
Keyboard failure
Keyboard stuck key failure
Memory address line failure at address,
read value expecting value
Memory allocation error
Memory data line failure at address, read
value expecting value
Memory double word logic failure at
address, read value expecting value
Memory odd/even logic failure at address,
read value expecting value
Memory write/read failure at address, read
may not match the hardware
configuration.
A cable may be loose, or the
diskette may be faulty.
The diskette drive controller may be
faulty.
The diskette write-protect feature is
activated.
No diskette is in the drive. The
operation requires a diskette in the
drive before it can continue.
The system could not complete the
boot routine.
One or more RIMMs may be loose.
The operating system is unable to
carry out the command.
The hard-disk drive failed
initialization.
The hard-disk drive failed
initialization.
This message appears for a dual-
processor system if both
processors do not have the same-
size level-2 cache.
The system configuration
information does not match the
hardware configuration.
A cable or connector may be loose,
or the keyboard or keyboard/mouse
controller may be faulty.
One or more RIMMs may be faulty
or improperly seated.
The software you are attempting to
run is conflicting with the operating
system or another application
program or utility.
One or more RIMMs may be faulty
or improperly seated.
See "Troubleshooting Drives."
Run the Diskette tests in the Dell
Diagnostics.
Remove the diskette from drive A and
move the write-protect tab to the
unlocked position.
Put a diskette in the drive or close the
drive latch.
Restart the system. If the error recurs,
listen for a beep code and refer to
2. If no beep code is emitted, run the
System Board Devices tests in the
Diagnostics.
See "Troubleshooting System Memory."
This message is usually followed by
specific information—for example,
PRINTER OUT OF PAPER. Respond
by taking the appropriate action.
See "Troubleshooting Drives."
See "Troubleshooting Drives."
Replace one of the microprocessors to
make the level-2 cache sizes match. If
you need technical assistance, see
"Getting Help."
NOTE: This message indicates a fatal
error. When a fatal error occurs, the
system usually cannot be rebooted
until an appropriate hardware change
has been made.
Enter System Setup and correct the
system configuration information.
See "Troubleshooting the Keyboard."
See "Troubleshooting System Memory."
Turn off the computer, wait 30 seconds,
and then turn it on. Try to run the program
again. If the problem persists, contact the
software company.
See "Troubleshooting System Memory."
Table
Dell