INSTALLATION REQUIREMENTS
Worksurface
Dimensions
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Required
•
Measuring tape
•
Level
The worksurface can be installed on top of a front-loading
washer
and dryer pair situated next to each other. The washer and dryer
must be level side to side and front to back and at the same
height. Proper installation is your responsibility.
Installation
Spacing
•
The worksurface will fit on top of a washer and dryer that are
each 27" (68.6 cm) wide and have a spacing of approximately
1" (2.5 cm) between them for the alignment pads.
1 u
(2.5cm)
25"
(63.5 cm)
>-\
Top view
NOTE: The worksurface will add 3" (7.6 cm) to the overall height
of your washer and dryer.
Front edge
!
27 3/8"
|
27 3/8"
(69.5 cm)
_
_ "_--
(69.5 cm)
--_="
•....-J_| |-4r--
(2,5 cm)
Bottom view
A. Alignment pads
B. Side pads
Back edge