Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Required
Phillips screwdriver
•
Level
9/16"(14 mm) open-end
•
Measuring tape
wrench (for leveling leg
Iocknuts)
Parts Supplied
•
Console
•
Screws (2)
•
Brackets (2)
A
A. Console
B. Bracket
B
Your laundry tower can be installed freestanding or between your
washer and dryer. Proper installation is your responsibility.
Installation
Clearances
•
The location must be large enough to allow the drawers to be
fully opened.
•
When you are installing your laundry tower between or next to
your washer and dryer, a spacing of 1" (2.5 cm) on the sides of
the laundry tower is recommended
to reduce noise transfer.
•
Additional spacing should be considered for ease of
installation and servicing.
Laundry Tower Dimensions
385/8''*
(98.1 cm)
36"*
[_
(91.4 crn)
251/8 ....
(63,8
cm)
42.J8"
_*_
(108,8 cm)
*Includes leveling feet
**Includes drawer front
INSTALLATION INSTRUCTIONS
Excessive
Weight Hazard
Use two or more people to move and install
laundry
tower.
Failure to do so can result in back or other injury.
1. Using two or more people, situate the laundry tower near its
final location. Open the drawers to remove any contents
stored inside.
2.
Using a Phillips screwdriver, remove the 2 outside screws
from the back of the laundry tower top panel and discard
them.
A
A. Outside screws
Advertisement
Table of Contents
