Refrigerator Use; Adjust The Doors; Opening And Closing Doors; Using The Controls - Maytag MFI2269VEQ3 User Instructions

Table of Contents

Advertisement

Available languages

Available languages

IMPORTANT:
Your refrigerator has two adjustable, front leveling screws -
one on each side of the refrigerator base. If your refrigerator
seems unsteady or you want the door to close easier, use the
instructions
below.
Before moving the refrigerator, raise the leveling screws so
the front rollers are touching the floor.
1. Remove the base grille. Grasp the grille firmly and pull it
toward you.
2=
Raise or lower the cabinet.
Using a V4"hex driver, turn the leveling screw on each side to
raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws. This
makes it easier to turn the screws. It may take several turns of
the leveling screw to adjust the tilt of the refrigerator.
To raise, turn the leveling screw clockwise.
To lower, turn the leveling screw counterclockwise.
REFRIGERATOR USE
There are two refrigerator compartment
doors. The doors can be
opened and closed either separately or together.
There is a vertically-hinged
seal on the left refrigerator door.
When the left side door is opened, the hinged seal
automatically
folds inward so that it is out of the way.
When both doors are closed, the hinged seal automatically
forms a seal between the two doors.
A
A. Hinged seal
3=
A. Leveling screw
Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling screws clockwise.
It may take several
more turns, and you should turn both screws the same
amount.
4. Replace the base grille.
The control center is located on the front of the ice and water
dispenser.
Temperature
Controls
For your convenience, your temperature controls are preset at
the factory. When you first install your refrigerator, make sure the
controls are still set to the recommended
set points as shown.
Recommended
Setting
IM PO RTANI"."
When the power is on, the temperature display shows the set
point temperature of the compartment.
Wait 24 hours for your refrigerator to cool completely
before
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended
setting will not cool
the compartments
any faster.
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents