Removing The Upper Rack - Maytag Jetclean MDB6650 User Manual

÷@@@@®®@@@@@@@@@@@@@@®®@@@@@@@@@@@@@@®®@@@@@@@@@@@@@@®®@@@@@@@@@@@@@@®®@@@@@@@@@@@@@@®_
Split & Fit
TM
Utensil Basket
The split silve_are basket can be separated and placed in
several locations in the bottom rack. Hold the basket
firmly along the sides. Follow the unlock direction arrows
imprinted on the basket and slide the basket apart until it
splits into two. Load flatware and utensils into both sec-
tions or just one, depending upon your load.
For best cleaning results, prevent items tiom nesting
together by placing some items in the basket with han-
dles up and some with handles down. Load knives, han-
dles up, through the slots in the hinged covered sec-
tion(s) (when closed).
Be sure that thin, finely pointed items do not extend
through the basket. This could block the lower wash
arm.
Small, lightweight items like baby spoons and plastic
measuring spoons should be placed in the section(s)
with the hinged cover(s).
Long-handled utensils such as spatulas and wooden
spoons should be loaded in the sections farthest fiom
the door.
\
\
_@_@@@@_@@@@_@@@@_@@@@_@@@@_@@@@_@@@@_@@@@_@
Removing the Upper Rack
The upper rack can be removed when tall or oversized
items need to be loaded into the lower rack.
To remove:
* Roll the upper rack 1/3 to 1/2 of the way out.
* Remove the plastic rack stop from the end of each
track. To remove each plastic rack stop, push in-
ward (towards the rack) on the ridged area of the
rack stop. The rack stop will snap open and can be
easily removed by pulling straight out. Take care to
support the track while removing rack stops.
Roll the rack all the way out of the track and
remove from the dishwasher.
Reverse the above procedure to replace the upper
rack into the dishwasher.
Rack
4