BEFORE YOU
CALL
For problem
laundry solutions (i.e. fabric damage, residue, tangling) and special laundry care procedures, see the
enclosed LaunderingTips
booklet.
•
Use Max Extract Spin Speed opdon.
Load isToo Wet at
• Try usinga high efficiency detergent to reduce sudsing.
End of Cycle
,
Load is too small. Very small loads (one or two items) may not be balanced and may not spin out
completely.
•
Hake sure door is firmly closed.
•
Hake sure hose connections are tight.
LeaksWater
•
Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid overloading.
•
Use high efficiency detergent to prevent over-sudsing.
• Check fuse or reset circuit breaker.
• Straighten drain hoses.Eliminate kinked hoses. If there is a drain restriction, call for service.
Won't
Spin
• Close the door and push the Start/Pause touchpad. For your safety,washer will not tumble or spin
or Drain
unless the door is closed.
• After pressingthe StarTJPause touchpad, it will take 30 secondsbefore the clothes washer beginsto
spin. The door must lock before spin can be achieved.
• See"Tub is Completely Fullof Suds"below.
• Plugcord into live electrical oudet.
• Check fuse or reset circuit breaker.
• Close door and push the Start/Pause touchpad to start the clothes washer. For your safety,washer
Stops
will not tumble or spin unlessdoor is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
• Check screens on inlet hoses at the faucets for obstructions. Clean screens periodically.
• Run the clothes washer through another complete cycle usingcold water.
Tub is Completely
• Reduce detergent amount for that specificload size,soil level and water hardness.
Full of Suds
• Use high efficiency or low sudsingdetergent speciallyformulated for front load washers.
• Turn both faucets on fully.
• Make sure temperature selection is correct.
Fills with the
• Hake sure hoses are connected to correct faucets. Flushwater lines.
Wrong
• Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot water at the tap.
Temperature
Also check water heater capacity and recovery rate.
Water
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• When
warm
rinse
is selected,
only
the
final
rinse
will
be
warm. The
first
two
rinses will be cold.
• As the washer is filling,the water temperature may change as the automatic temperature control
feature checks incoming water temperature. This is normal.
• The washer features an automatic temperature control to provide a warm wash of approximately
105" F and cold wash of approximately 65" E While the washer is filling,you may notice only hot
and/or only cold water going through the dispenser when cold or warm wash temperatures are
selected. This is a normal function of the automatic temperature control feature as the washer deter-
mines the temperature of the water.
2O
CONTINUED