Storing The Clothes Washer - Maytag MAH7500AWW User Manual

STORING THE CLOTHES WASHER
l
Washers can be damaged if water is not removed from hoses
and internal components before storage. Prepare the washer
for storage as follows:
• Select the "Cotton/Sturdy" and "Quick" setting and add
one cup of bleach to the detergent dispenser without
clothes in the tumbler. Run the clothes washer through a
complete cycle.
• Turn the water faucets off and disconnect the inlet hoses.
• Disconnect the clothes washer from the electrical supply and
leave the washer door open to let air circulate inside the tum-
bler.
• Ifthewasherhasbeenstoredinbelow-freezingtemperatures,
allow time for the water left over in the washer to thaw out
prior to use.
For information on long-term storage or storage of your washer during extreme cold temperatures,
call Maytag Customer Service toll-free at 1-888-462-9824,
U.S. customers usingTTY for deaf, healing impaired or speech impaired, call 1-800-688-2080.
REPLACING INTERIOR LIGHT
Instructions for replacingthe bulb:
I) Unplug or disconnect the clothes washer from the electrical power supply.
2) Open the door.
3) Unscrew the light bulb counter clockwise from the socket.
4) Replace the bulb with a 10 watt candelabra base light bulb and rotate clockwise.
5) Plug in or reconnect clothes washer to the power supply.
i
REVERSING THE CLOTHES WASHER
DOOR
Clothes washer door swing direction can be changed using the following procedure:
I) Swing door fully open and support it while removing four hingescrews (which hold hingesto door assembly).
2) Move door to a work surface and transfer four color matched door screws to the opposite side of the door assembly.
3) Remove one screw holding top hingeto cabinet and one screw holding top hinge cover to cabinet (opposite side).
4) Remove hinge and bracket from cabinet by moving them up and clown to a position where they are released.
5) Install hinge and bracket in swapped locations and drive screws to attach them securelyto the cabinet.
6) Compare top hinge and top bracket to bottom hinge and bottom bracket for correct hinge assembly position.
7) Repeat procedures 4 through 6 for bottom hinge to cabinet and bottom bracket to cabinet.
8) Support door in fully open position on hinge side and drive four screws to securely attach hingesto door assembly.
9) Close door and check to see that clothes washer operates properly.
.......................
19