Before You Call For Service - Maytag LAT9605 User Manual

BEFORE YOU CALL FOR SERVICE
Check these points if your washer...
Plug cord into live electrical outlet.
Cheek fuse or reset circuit breaker.
• Tun] the control knob to proper cycle and pull knob out to stalt the washer. If
equipped with buttons, be sure they are fully depressed.
• Turn both t;ancets on fidly:
• Straighten inlet hoses.
• Hose filter screens plugged. Disconnect hoses and clean screens.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer. If
equipped with buttons, be sure they are tully depressed.
• Close lid and pull knob out to start the washen For your safety.
washer will not agitate or spin unless the lid is dosed.
• The washer is equipped _ith a lid switch failure detector. If the lid switch should
malfunction, the detector will stop operations for your safety'. Call for sea,ice.
• Olt:-balanee load. Redistribute the load evenly, close the lid and pull knob out. Check
for leveling. Be sure water level is acceptable for load size.
• Check fuse or reset circuit breaker.
• Straighten hoses. Ehminate kinked hoses. If there is a drain restriction, call for serdce.
• Close lid and pull knob out to start the washer. For your safety, washer will not
agitate or spin unless the lid is closed.
• Suds lock - caused bv too much suds. Rewash without detergent. Use correct
amount of a low-sudsing detergent.
• The washer is equipped with a lid switch failure detector. If the lid switch should
malfimetion, the detector will stop operations for your safet)c Gall for service.
• Off-balance load. Redistribute the load evenly; close the lid and pull knob out. Cheek
for leveling. Be sure water level is acceptable for load size.
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer. If
equipped with buttons, be sure they are fully depressed.
• Close lid and pull knob out to start the washer. For your safety; washer will not
agitate or spin unless lid is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
• The washer is equipped with a lid switch failure detector. If flm lid switch should
malfunction, the detector v¢ill stop operations for your safety,. Call for service.
• Make sure hose connections are tight.
• Make surc end of drain hose is correctly inserted and secured to drain facility.
• Extended soaking - soak for 30 minutes or less.
• Make sure washer is level and firm to the floor.
• Weak floors can cause vibration and walking.
• Turn both faucets on fully.
• If equipped with a temperature selector knob, be sure it is set directly on a temper-
ature setting and not between settings.
• Make sure temperature selection is correct.
• Make sure hoses are eom_ected to correct lancets and inlet connections. Be sure
water supply is regulated correctly'. Flush water line before t]lling washer.
• Cheek the water heater. It should be set to deliver a minimum 120°F (49°C)
hot water at the tap. Also check water heater capacity and recovery rate.
• Hose filter screens plugged. Disconnect hose and clean screens
NOTE: For further information contact Maytag Customer Assistance: U.S. 1-800-688-9900
Canada 1-800-688-2002
PAGE 8