Complete Installation - Maytag MTW5820TW0 Use & Care Manual

Table of Contents

Advertisement

Available languages

Available languages

3.
Check the levelness
of the washer
by placing
a level on the top edges of the washer, first
side to side, then front to back.
4.
If the washer
is not level,
move the washer
out slightly,
tip back, prop up the front of the
washer
with
the wood
block and adjust the feet up or down as necessary
by twisting
the
feet. Turn the feet clockwise
to raise the washer or counterclockwise
to lower the washer.
Repeat steps 1 through
4 until washer
is level.
5.
After the washer
is in the final
location
and level,
use a 9_6" or 14 mm open-end
wrench
to turn the nuts counterclockwise
on the feet tightly
against
the washer cabinet.
IMPORTANT:
[f the nuts are not tight against the washer cabinet,
the washer
may vibrate.
COMPLETE
INSTALLATION
1.
Check the electrical
requirements.
Be sure that you have the correct
electrical
supply
and
the recommended
grounding
method.
See "Electrical
Requirements."
2.
Check that all parts are now installed.
[f there is an extra part, go back through
the steps to
see which
step was skipped.
3.
Check that you have all of your tools.
4.
Check that the yellow
shipping
materials
were completely
removed
from the lower back
of the washer.
5.
Dispose
of/recycle
all packaging
materials.
6.
Check that the water faucets
are on.
7.
Check for leaks around
faucets
and inlet hoses.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter,
Do not use an extension
cord.
Failure to follow
these instructions can result
in death,
fire, or electrical
shock.
8.
Plug into a grounded
3 prong outlet.
9.
Remove the protective
film on the console
and any tape remaining
on the washer.
10. Read "Washer
Use."
11. lb test and to clean your washer,
measure 1/2of the normal
recommended
amount
of
powdered
or liquid
detergent
and pour it into the washer
basket or detergent
dispenser
Ion some models).
Close the lid. Select any cycle, and then pull the cycle control
knob
out to start the washer.
Allow
it to complete
one whole
cycle.
12

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents