Advertisement
Available languages
Available languages
3. Open t heshutoff valve inthesupply l ille,lhevalve isopen w hen thehandle i sparallel to
thegas pipe.
You canchange your d oor s wing f rom aright-side Ol:_ening
toa left-side opening, ifdesired.
4.
A. Closed valve
B. Open valve
[_st all connections
by brushing
on an approved
noncorrosive
leak-detection
solution.
Bubbles
will show a leak. Correct
any leak found.
Co nect %n
1.
Using a 4" (102
cm) clamp,
connect
vent to exhaust
outlet
in dryer. If connecting
to
existing
vent, make sure the vent is clean, The dryer vent must fit over the dryer exhaust
outlet
and inside the exhaust
hood.
Check that the vent is secured to exhaust
hood with
a
4" (10,2 cm) clamp.
2.
Move dryer into its final
location.
Do not crush or kink vent.
3.
(On gas models)
Check that there are no kinks in the flexible
gas line.
4.
Once the exhaust
vent connection
is made, remove
the corner posts and cardboard.
Check the levelness
of the dryer. Check levelness first side to side, then front to back.
If the dryer is not level, prop up the dryer using a wood block,
Use a wrench
to adjust the legs
up or down
and check again for levelness.
1.
Place towel
(A) on top of dryer to protect
surface.
2.
Open dryer door. Remove bottom
screws from cabinet
side of hinges (C). loosen
(do not
remove) top screws from cabinet
side of hinges.
3.
I.ifl door until top screws in cabinet
are in large part of hinge slot. Pull door forward
off
screws, Set door (handle
side up) on top of dryer. Remove
top screws from cabinet
4.
Remove screws attaching
hinges to doon
5.
Use a small, fiat-blade
screwdriver
to gently remove
4 hinge hole plugs (D) on left side of
cabinet.
Insert plugs into hinge holes on right side of cabinet
6.
insert screws into bottom
holes on left side of cabinet,
lighten
screws halfway,
Position
door so large end of door hinge slot is over screws. Slide door up so screws are in bottom
of slots. Tighten screws,
insert and tighten
top screws in hinges.
Close door and check that door strike aligns with door catch (B). If it is needed,
slide door
catch left or right within
slot to adjust alignment.
¸¸i¸7¸¸¸
%
!! {lll{l_i7!!iii!iiii_ii!!iiiiiiiiiiiiii77iiii_{{!!;!_#ii_i{{i_i{{i_i{{i_i{{i_i{{i_i{{i_i{{i_i{_
i_ii!_ii!_ii{i!iii:!!iSii 13
Advertisement
