Philips VR1010BP Owner's Manual page 61

Search O ptions 61
Index Search
When you make a recording, theVCR automatically places an
index code at the beginning of the recording. Essentially, an index
code is a type of"bookmark" for your tape.This feature is useful if
you have several different programs recorded on a single tape.
Fast forward or rewind to the next or previous index code on the
tape by following the steps below.
I
Press theVCR button. Make sure theVCR is inVCR position.
(TheVCR light will appear on the display panel when theVCR is in
VCR position.) If the VCR light does not appear, press the
VCR/TV button once.
Insert a tape in theVCR. Press the INDEX SEARCH I_1_1
button to fast forward to the next index code on the tape.
Or_press the INDEX SEARCH button I_1_1 to rewind to
the previous index code on the tape (or to the beginning
of the current recording).Wait for the VCR to fast forward or
rewind the tape.When the index code is reached, tape playback
will begin automatically.
NOTE:You may press an INDEX SEARCH button repeatedly to
skip over multiple recordings. For example, if you want to fast for-
ward past four recordings, press the INDEX SEARCH I_1_1 but-
ton four times. INDEX 4 will appear in the bottom right corner of
the screen.The index codes will count clown on the screen as the
search progresses. (ON SCREEN MODE can not be set to OFF.
Details are on page 28.)
VCR_TV pOWER SM_Rn_:run_
,_spr_c D_IL¥ WE_
VOL O_ STATUS _H
TiNE_
Skip Search
This function enables you to skip forward 30 seconds at a time
during tape playback.
I
During tape playback, press theVCR button, then press
the SKIP SEARCH button. Eachtime you pressthe SKIP
SEARCH button, the tape will skip forward 30 seconds, then
resume normal playback. You can skip up to two minutes at a time
using Skip Search.
Helpful Hints
To stop an Index Search that is in
progress,press the STOP • button.
The VCR does not place an index
code at the point where a recording is
paused, then resumed.
INDEX may flash on the screen
briefly when you begin a recording.
Pressthe STOP • button to cancel a
Skip Search.
If the end of the tape is reached dur-
ing a Skip Search or an Index Search,
the VCR will cancel the search and
rewind the tape.
The Index Search will not work if the
Tape Manager is in use. Details are
on pages 64-73.