Philips 36PT8320 Directions For Use Manual page 51

Wven using the TV remote control with a
CR, .first make certain it is set to con-
trol your VCR (by the REMOTE CODE o1"
SEARCH method).
Set the TV/VCR/ACC mode switch
to VCR on the remote control.
Point the top of the remote toward
the front of the VCR (remote sensor
window) when pressing the buttons.
VCR System Switch
Set in the VCR position to send remote com-
mands to the VCR,
Record Button
Hold the REC(ord/Sap) and PLAY I_ buttons
down to begin a VCR recording.
Play Button I_
Press to begin playback of a videotape.
Rewind Button "41"41
Press to rewind tapes. For some VCR's, the
STOP button may have to be pressed first,
then REWIND. In playback mode, hold
down the button to view the picture moving
rapidly in reverse.
Stop Button •
Press to stop the motion of a tape in play-
back, rewind, fast forward, and so on,
Remembel; the VCR buttons on the remote will
not operate your VCR if those features are not
found on your VCR remote control.
NOTE: All VCR ftmctions (particularly
Search, Rewind, Fast Forward, etc.) will oper-
ate the stone as with the original VCR remote
control provided with the VCR.
\
\
PHILIPS
Button
Press to turn the VCR ON and OFF.
Button
Press while in the VCP, mode (the VCR indi-
cator on the front of the unit will light) to view
the playback of a tape. Press again to place in
the TV position (the VCR indicator light will
go off) to view one program while recording
m_other program.
Buttons
Press buttons for the direct selection of
VCR channels.
+ and - Buttons
Press to scan up or down through the VCR
channel numbers,
Press to rapidly advance the tape. For some
VCRs, you may need to press the STOP
button first, then the FAST FORWARD
button. In playback mode, hold the button
down to view the picture moving rapidly in
the forward direction,
Pause Button II
Press to temporarily stop the tape during a
playback or recording. Press again to
release Pause,
51