Magic Chef CER3525AAW User Manual page 12

To cancem the Clock display:
If you do not want the thne of day to dispiay:
Press and hoid the CANCEL and CHockpads .... .....
for three seconds. The time of day wiii
disappear from the dispiay
When the chock dispiay is cancelled, press
the CHockpad to brbfiy dispiay the time
of day.
To restore the Clock display:
Press and hoid the CANCEL and CHockpads for three sec-
onds. The time of day wiii reappear in the dispiay.
-- CLOCK
The timer can be set from one minute (00:01} up to 99 hours
and 59 minutes @9:59}.
The timer can be used independently of any other oven
activity. It can also be set while another oven function is
operating.
The Timer does not control the oven. It only controls a
beeper.
To set the Timer:
1.
3,
s¢_ ¸_¸ ,_
Press the Timer pad. nMER
.0:00 iights in the dispiay.
, The coion flashes in the dispiay.
Press the A or V pad untii the
correct time appears in the dispiay.
, The coion wiii continue to flash.
Press Timer pad again or wait four seconds.
° The colon continues flashing and the time begins
counting down.
° The last minute of the timer countdown wiii be displayed
as seconds.
4. At the end of the set time, one long beep wiii sound.
To cancel the Timer:
1. Press and hold the Timer pad for three seconds.
OR
2. Press the Timer pad and set the time to 00:00.
Locking the Controms
The touchpad controls can be locked for safety',cleaning, or
to prevent unwanted use. They will not function when locked.
If the oven is currently in use, the controls cannot be locked.
The current time of day will remain in the display when the
controls are locked.
To leek:
Press and hold the CANCEL and Cook &
Hold pads for three seconds.
LOCK flashes in the display.
To unmoek:
Press and hold the CANCEL and Cook & Hold
pads for three seconds.
LOCK disappears from the display.
COOK&
HOLD
Fault Codes
BAKE or LOCK may flash rapidiy in the dispiay to aiert you if
there is an error or a problem. If BAKE or LOCK flash in the
display, press CANCEL pad. If BAKE or LOCK continue to
flash, disconnect power to the appliance. Wait a few minutes,
and then reconnect power. If the flashing still continues,
disconnect power to the appliance and call an authorized
servicer.
To set Bake:
1.
Press the Bake pad. BAKE
° "BAKE" wiii flash.
° 000 wiii iight in the display.
2. Select the oven temperature. The oven tempera-
ture can be set from 170° to 550°. Press or press
and hold the A or V" pads.
° 350 ° wiii iight when either pad is first pressed.
, Press the A pad to increase the temperature.
, Press the V pad to decrease the temperature.
3. Press Bake pad again or wait four seconds.
° BAKE will stop flashing and light in the display.
V
11
° 100° or the actual oven temperature wiii display. The
temperature will rise in 5° increments until the preset
temperature is reached.
4. Allow the oven to preheat for 8-15 minutes.
° When the set oven temperature is reached, one long
beep will sound.
° To recall the set temperature during preheat, press the
Bake pad.
5. Place food in center of oven, allowing a minimum of two
inches between utensil and oven walls.