System Installation - Sharp SD-AT1000 User Manual

System installation

SD-AT1000H
ENGLISH
! Placing the speaker system
The best surround effect will be achieved by placing each speaker at the same
distance from the listening position.
It is recommended to arrange the speakers as shown below.
Front
speaker (left)
Subwoofer
Surround
speaker (left)
Note:
The default distance is set to 2 m. If speakers cannot be placed at equal distances,
refer to "Speaker delay setting" (see page 23).
Installation image:
The speaker stands and speaker wall brackets are optionally available (see page 2).
Refer to their instructions for assembly.
E-13
Centre
Front
speaker
speaker (right)
Default setting:
2 m
Surround
speaker (right)
Notes:
" Place the TV halfway between the front speakers.
" It is recommended that the centre speaker be placed near the television.
" Place the surround speakers at a position just above the height of your ears.
" The subwoofer vibrates whilst reproducing bass. Place it on a stable, sturdy sur-
face.
" The subwoofer reproduces bass. Place it anywhere you like.
Centre speaker
Same distance
Front speaker (left)
! Magnetically shielded speakers
The front, centre and subwoofer speakers may be placed beside or near the TV as
they are magnetically shielded. However, discolouration may occur depending on the
TV type.
If colour variation occurs...
Turn off the TV (from the power switch).
After 15 - 30 minutes, turn the TV on again.
If the colour variation is still present...
Move the speakers further away from the TV.
Refer to the user's manual of the TV for details.
Note:
The surround speakers are not magnetically shielded.
03/3/14 SD-AT1000H_SEEG_E.fm
Same distance
Front speaker (right)
TINSZ0943AWZZ