General Control; Muting Button; 15.Dimmer Button; Volume Up And Down Buttons - Sharp SD-AT1000 User Manual

General control

SD-AT1000H
ENGLISH
Display
E-15
! To turn the power on
Press the ON/STAND-BY button.
If the power does not turn on, check the AC power lead is plugged in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
! To change the display brightness (2 levels)
You can switch the display brightness by press-
ing the DIMMER button.
! Volume control
Main unit operation:
When the VOLUME control is turned clockwise,
the volume will increase. When it is turned anti-
clockwise, the volume will decrease.
Remote control operation:
Press the VOLUME + button to increase the vol-
ume and the VOLUME - button for decreasing.
! Muting
The volume is muted temporarily when pressing
the MUTING button on the remote control.
Press again to restore the volume.
! Headphones
" Before plugging in or unplugging the headphones, reduce the volume.
" Be sure your headphones have a 6.3 mm (1/4") diameter plug and are between 16
ohms and 50 ohms impedance. The recommended impedance is 32 ohms.
" Plugging in the headphones disconnects the speakers automatically. Adjust the
volume using the VOLUME control.
" You cannot use the surround feature with headphones.
" Do not plug in or unplug headphones whilst recording. The sound may skip.
03/3/14 SD-AT1000H_SEEG_E.fm
Dimmed
.....
0 1 2 39 40
TINSZ0943AWZZ