Maintenance; For Assistance - KitchenAid KWCU265HWH1 Installation Instructions And Use And Care Manual

Maintenance
Replacing the light bulb:
This range hood uses fluorescent
lamp type F33-15W-T8 and starter
type 52.
Remove the retainer clips from both
ends of the light cover. Carefully
slide the cover all the way to the
right. Then lower the left end of the
glass below the support flange and
remove the glass by sliding it back
from the left.
install a new fluorescent light bulb.
Position the right end of the light
cover over the flange and slide the
cover all the way to the right.
Position the left end of the light cover
over the flange and slide the cover
back to left. Reinstall the retainer
clips.
retainer
clips
support
flange
Speed Control Slide Switches
,
I
L ......
I
BLU :3 I ORG I
j Z
iZ
I
......... 4
it2@ UAC 3
58Hz
For assistance:
If you have questions about operating,
cleaningor maintainingyour range hood:
[] Call the KitchenAid Consumer
Assistance Center, 1-(800) 422-1230.
if you need service:
Maintain the quality built into your
appliance by calling a KitchenAid-
authorized service company. To obtain
the name and number of an authorized
service company:
[] Contact the dealer from whom you
purchased the appliance;
[] Look in theYeiiow Pages of your
telephone directory under "Appliances
- Household - Major - Service and
Repair;"
[] Cai[ the KitchenAid Consumer
Assistance Center, 1-(800) 422-1230.
Note: instructions are included with
each kit.
Backsplash*: Must be installed before
hood is installed. Stainless steel only.
Part No. 8171295 30" (76.2 cm)
Part No. 4378615 36" (91.4 cm)
Part No. 8171296 48" (121.9 cm)
Utensil Bar: Stainless steel only
Part No. 4378619 (side)
15" (38 cm) long
Part No. 8171299 (back)
30" (76 cm) long
Part No. 4378618 (back)
35-3/8" (90 cm) long
Charcoal Filters:
Part No. 4378623 (2 per pkg.)
Non-Vented (Recirculating) Kits*:
Part No. 4378621 (stainless steel)
Part No. 4378622 (white)
Part No. 8171290 (biscuit)
Wire Rack: Chrome only
Part No. 8171297 30" (76.2 cm)
Part No. 4378616 36" (91.4 cm)
Part No. 8171298 48" (121.9 cm)
Rack Hanger Kit: Chrome only
Part No. 4378617
Chimney Extensions*:
Part No. 8171313 (stainless steel)
Part No. 8171315 (biscuit)
Part No. 8171314 (white)
*These instructionsmust be read
before starting the canopy hood
installation.