Table of Contents
Advertisement
Before Setting Surface Controls
(cont'd)
Assembly
of the Surface
Burner
Heads, Burner
Caps and Burner
Grates
It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates
are installed correctly and at the correct locations.
1. Be sure to follow the Installation
instructions when installing your new
cooktop.
2. Remove all packing tape from cooktop.
Remove Burner Caps and Burner
Heads (See Figure 1).
3. Discard all packing material located
under all Burner Heads (if applicable).
4. To replace Burner Heads & Caps,
match the letters located under center
of Burner Caps with the letters located
30I' Cooktop Layout
5K
_h¢i
:
16.2K
t_
9 K
i!i_i!i! iii!iiii!i
36" C0oktop Layout
Example of Burner Assembly
Match letter located
II
Head
inside Burner Head (only 5K, 9.5K and
16.2K burners are marked with letters -
See Figure 1 ). Place all Burner Heads
& Caps on the cooktop (See Figure 1)
while carefully aligning the Electrodes
into slots or holes of the Burner Heads
(Figure 3). Note: The Burner Heads
should sit flat on Cooktop Burner
Skirts.
5. Replace Bridge Burner Caps. These include one Bridge
Burner Center Cap (rectangular shaped) and the two
Bridge Burner End Caps (The Bridge Burner End Caps
will fit either the front or rear Bridge Burner Head
...........
ii
ii
iliii i
9.5K
o
Figure 1
Bridge Burner Head
Burner
Head
Burner Skirt
Bridge
Burner
locations). Make sure that the tabs located under the
Bridge Burner Caps fall into the slots located in the
Bridge Burner Head (See arrows in Figure 2) and that all
the Bridge Burner Caps lie flat and evenly on the Bridge
Burner Head.
6. Unpack Burner Grates. NOTE: Do not force End Burner
Grates down on cooktop. Be careful to line up the 2
Grate Pins located on each of the 2 End Burner Grates
into the Pilot holes located on top of the Burner Caps
(See Figure 4). Position Burner Grates on cooktop and
check that all the Burner Grate legs lie on the glass
surface.
7. Place Center Burner Grate between the end Burner
Grates (36" models only).
End
Cap
Figure2
Bridge
Burner
Center
Cap
Bridge
Burner
End
Cap
properly in slot of each
Burner Head
Figure3
Grate Pin
_
urner
Cap
Pilot Hole
Figure4
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE
GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface
burners are in use.
Advertisement
Table of Contents
