Setting Surface Controls - Kenmore ELITE 790.3322 Series Use & Care Manual

Setting Surface Controls
Sizes of the Surface Gas
Burners
Your appliance is supplied with the
following 3 different surface gas
burners:
Simmer Burner (5,000 BTU)
1 (or 2 on 36" models) Standard
Burners (9,500 BTU)
1 Power Burners (12,000 BTUI
• Power Burner (16,000 BTU)
Burner CaD
Extra _arge -,_
"POWER"
Burner Head
,12.000 BTU
When setting up the range for
the first time, make sure that the
correct Burner Heads, Burner
Caps and Burner Grates are
located as shown in Figure 1.
Burner Cap
_Gas
36" Models
only
Burner Cap
(Standard)
36" Models only
Burner Head Burner Head
BTU/ (9.500 BTU/
Center
Left Front Gas Opening Sma
Gas Opening
Extra Large _)-_--"SIMMER
Burner CaD Burner Head
5.00C BTU
"POWER"
Burner Head Right Rear
16.000 BTU Gas Opening
R ght Fronl
Gas Opening
Figure 1
Burner
Cap
Burner
Head
Gas
_ F
upenmg
Electrode must be
located properly in slot
of each Burner Head
Figure 2
Assembly
of the Surface Burner
Heads, Burner Caps,
Burner Grates and Flue Covers
It is very important to make sure that all of the Surface Burner Heads,
Surface Burner Caps and Surface Burner G rates are installed correctly
and at the correct locations.
1. Place all 4 (four) or 5 (five) Burner Heads in the correct locations
(See Figure 1). Make sure that the correct Burner Head is placed
with the corresponding Gas opening and that the Electrode is
located properly in the slot of each Burner Head (See Figure 2).
Proper Burner Head placement insures that each Burner will have
the correct spark required for surface gas ignition.
2. Place the correct Burner Caps at each of the burner locations
(Burner Cap Pilot Hole must face up). Each of the 4 (four) Burner
Heads MUST have a Burner Cap installed to insure proper ignition
and gas flame size and must be in place with the Pilot Hole facing
up BEFORE placing the Burner Grates (See Figure 2).
3. Place the 2 (two) or 3 (three) cast iron Burner Grates supplied with
the range. Carefully lift the burners grates on to the cooktop over
the burners. Properly installed Burner Grates will rest with all Grate
legs on the cooktop.
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
OPENING. Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use.