Kenmore ELITE 790.4637 Series Use & Care Manual page 9

Setting Surface Controls
Surface Cooking Settings
Use the chart (Figure 1) to determine the correct setting for the kind of food you are
preparing. The Simmer settings are used to simmer and keep larger quantities of foods
warm such as stews and soups. The lower Simmer settings are idea[ for delicate foods
and melting chocolate or butter.
Note: The size and type of cookware used will influence the setting needed for best
cooking results.
Recommended Settings for S{ngIe and
Duat Surface Elements
HIGH(Hi)
MEDIUM HIGH (5-8)
MEDIUM (5)
MEDIUM LOW (2 z4)
LOW (Lo-2)
Start most foods, bring water to a boil, pan broiling
Continue a rapid boil, fry, deep fat fry
Maintain a slow boil, thicken sauces and gravies, steam
vegetables
Keep foods cooking, poach, stew
Keep warm, melt, simmer
Figure 1
Operating Single Radiant Surface Elements
The cooktop has single radiant surface elements at 2 locations; the right rear and left rear
(Figure 2) element positions.
To Operate the Single Surface Elements:
1. Place correctly sized cookware on the radiant surface element.
.
Push in and turn the surface control knob in either direction to the desired setting
(Figure 3). Turn the knob to adjust the setting if desired. Start most cooking
operations on a higher setting and then turn to a lower setting to finish cooking. Each
surface element provides a constant amount of heat at each setting. A glowing red
surface heating area extending beyond the bottom edge of the cookware indicates the
cookware is too small for the surface heating area.
When cooking has completed, turn the surface control knob to OFF before removing Lo
the cookware. Note: The Hot Surface Indicator light wiI[ come on when the control
knob is turned on and will continue to glow until the glass cooktop has cooled down to G -_
a moderate level. The light may remain on even though the controls are turned OFF. 2
Note: See above, Figure 1 for recommended control settings.
_Radiant
surface elements may
appear to have cooled after
they have been turned off. A
hot surface indicator light
will come on and will
continue to glow until the
glass cooktop has cooled
down to a moderate level.
The glass surface may
still be hot and burns may
occur if the glass surface is
touched before the indicator
light has turned off.
Do not place
pmastic items such as salt
and pepper shakers,
spoon holders or plastic
wrappings on top of the [
range when it is in use.
iiii
These items could melt or ........
}
ignite. Pothoiders, towels or ::
wooden spoons could catch ::::11
fire if placed too close to the
surface elements.
Figure 2
Right Rear & Left Rear
Elements
OFF
HI
8
\
7
4 6
MED
Figure 3