Door Removal Instructions; Door Handle Mounting Instructions - Kenmore ELITE 253.4475 Series Use & Care Manual

Door Removal instructions
Door Handle Mounting instructions
1. Remove handle from carton and any other protective
packaging.
2. Position freezer handle end caps over upper and
lower pre-instaiied shoulder bolts (A) that are
fastened into door, ensuring the holes for the set
screws are facing towards the outside of door if it is
a single unit installation, or towards the refrigerator
door if installing the matching refrigerator.
3. While holding handle firmly against door, fasten
upper and lower Alien set screws (B) with supplied
Alien wrench.
4. Repeat steps 2 and 3 to install refrigerator handle (if
installing the matching refrigerator). Ensure the holes
for the set screws are facing towards the refrigerator
door.
NOTE
All set screws should be tightened and sub-flush of
handle end cap (set screw is seated just below the
surface of handle end cap). The end caps should be
drawn tight to freezer door with no gaps.
Single Unit installation
Kick Plate Removal
To remove the kick plate, use a Phillips head screwdriver
and remove the two screws holding the kick plate to the
cabinet. Then pull the kick plate away from the unit.
Kick Plate Removal
Matching Refrigerator and Freezer Door Handle Installation