Door Removal - Kenmore 253.7041 Use & Care Manual

Door Removal Instructions (Continued)
4. Unscrew the three lower hinge screws
and hinge if necessary.
To reinstall the right door, reverse the
above steps.
Lower Hinge Removal
Once both doors are in place, ensure they
are aligned with each other and level (Please
see the "Installation" section for more details),
and replace the top hinge cover.
CAUTION
Be sure doors are set aside in a secure
position where they cannot fall and cause
personal injury, or damage to the doors or
handles. When reinserting the water tube
and replacing the top hinge cover, use
care to be sure you do not kink the tube.
Removing Freezer Door
1. Open freezer door.
2. Remove door screws on right and left
sides (two screws on each side).
Remove
CAUTION
Door is heavy. Use caution when lifting.
3. Lift door up and out to remove.
Installing Freezer Door
1. With lower slides pulled out, hang
door onto slide brackets ensuring pins
on each side are fully inserted into
slots on each side.
Do NOT
Remove
Pin
2. Reinstall screws (two per side), fully
finger tighten, and close door.
Reinstall
and
tighten
till
finger
tight
3. Check gasket seal around top,
bottom, and sides of freezer door. If
gasket is not sealed, rotate door until
the gasket is sealed.
4. Open door by grabbing in the center
sides of the door. Be careful not to
rotate door when opening.
Push
Against
Freezer
Door
Check
Seal
5. Tighten large bolts.
Fully
tighten
large
bolts
6. Recheck gasket seal.
7. Install the toe grille by fitting into place.
13
Cabinet
Slot
Do
NOT
Remove
Grab
Door
at Center
from Both
Sides
Then
Pull
Door
Out
Do
NOT
Remove