Installation; Required Tools - Kenmore ELITE 253.4475 Series Use & Care Manual

Installation
Required Tools
You will need the following tools:
Components Provided:
Top Hinge Top Hinge
Cover Front Cover Rear
s . ... ....
skine c_e Lsk!rn_r _
Tools Necessary:
_% oR
Head
3/8"Fixed
Wrench
This Use & Care Guide provides general installation and
operating instructions for your model. We recommend
using a service or Idtchen contracting professional to install
your freezer. Use the freezer only as instructed in this Use
& Care Guide. Before starting the freezer, follow these
important first steps.
Location
° Choose a place that is near a grounded, non-GFCI,
electrical outlet. Do Not use an extension cord or an
adapter plug.
* If possible, place the freezer out of direct sunlight
and away from the range, dishwasher, or other heat
sources.
* The
freezer
must be installed on a floor that is level
and strong enough to support a fully loaded freezer.
_ CAUTION
Do not install the freezer where the temperature will
drop below 55°F (13°C) or rise above 110°F (43°C).
The compressor will not be able to maintain proper
temperatures inside the freezer.
Do not block the kick plate on the lower front of your
freezer. Sufficient air circulation is essential for the
proper operafion of your freezer.
Installation
* Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
Sides & Top 3/8 inch (9.5 mm)
Back 1 inch (25.4 mm)
NOTE
If your freezer is placed with the door hinge side against
a wall, you may have to allow additional space so the
door can be opened wider.
7