Advertisement
WARNING
,, ALL RANGES
CAH
T!]P
,, INJURY
COULD
RESULT
o IINSTALL
ANTII=TIP
DEVICE
PACKED
WIITH
RAHGE
SEE
IHSTRUCTiiON$
STAEIIILITY
DEVICE
INS1FAILILATION
liNSTRUCTIOHS
FOR
5RACKET
KIlT
HO.
342473
Phillips
head screwdriver
1-3/8" open end or adjustable
wrench
TOOLS NEEDED:
Bracket attaches to floor or wall to hold either right or left
rear leg leveler. If fastmling
to floor, be sure that screws
do not penetrate electrical
wiring or plumbing.
If this
cannot be determined,
use shorter screws that will not
penetrate through flooring.
If the bracket came with your range, it is shipped at-
tached to the lower
range back° Remove and discard
the shipping
screw
that holds the bracket and then
follow instructions below.
1. Decide whether the bracket will be installed on the
right or left side of range location.
2. if the bracket side of the range is adjacent
to a
cabinet, place the bracket
against
back wall and
cabinet as shown In Figure 1.
If there is no adjacent cabinet, determine where the
location of the range side (painted outside panel) will
be. Place the bracket with its outside edge at this
location and against back wallo See Figure 1.
OUTSIDE
EDGE OF
BRACKET TO BE
FLUSH WITH LEFT OR
RIGHT SIDE OF RANGE
WALL
BEHIND
RANGE
Fig° 1
ADJACENT
CABINET
OR FINAL
LOCATION
OF RANGE SIDE
PANEL
"-"_-
3. Determine whether you will anchor the bracket to the
floor or wall, Fasten the bracket securely with the
screws provided.
Screws are self-drilling in wood,
plywood, particle and chip board, and most metal
framing°
Ifattaching to masonry you can buy suitable
screws
and anchors
at hardware
stores.
Use a
masonry drill to drill the required holes.
4. Using the wrench, back out the four leg levelers at
least two turns. See your installation guide for more
leveling information before positioning range.
5. Slide the range into place.
Be sure rear leg leveler
fully engages
slot in bracket.
If range cannot be
moved back far enough for rear leg leveler to enter
bracket, move bracket forward as required and attach
to floor in new location°
BRACKET
\
SCREW MUST ENTER "X_
WOOD OR METAL
WALL
PLATE
/
Fig, 2
ATTACHMENT
TO WALL
4
NCINS01
Advertisement
