Panasonic KX-VC300 User Manual page 13

If the unit has been used before
If you are already using this unit in IP Mode, follow the
procedure below to configure the network settings.
1.
Press [Menu].
•
The Menu screen is displayed.
2.
Use [ ][ ] to select "Settings" and press
[Enter].
•
The system settings screen is displayed.
3.
Press [ ] twice.
•
The third page is displayed.
4.
Use [ ][ ] to select "Admin login" and press
[Enter].
•
The login screen is displayed.
5.
Use [ ][ ] to select "Password", then enter the
administrator password (4–10 digits).
Note
•
Please enter the administrator password
that was set during installation.
•
If you forget the administrator password,
please contact your dealer.
6.
Use [ ][ ] to select "Login" and press [Enter].
•
The admin menu screen is displayed.
Document Version 2012-03
Setting up KX-VC Series NAT Traversal Service
7.
Use [ ][ ] to select "Connection mode" and
press [Enter].
•
The connection mode setting screen is
displayed.
8.
Press [Enter] and use [
Traversal Mode".
Note
•
Communication cannot be established with
a party whose connection mode setting
differs from yours.
9.
Press [G].
•
A dialog box to confirm the saving of settings
and system restart after saving is displayed.
10.
Select "Yes" using [
•
After the unit restarts, the network settings
screen is displayed.
Note
•
Restarting may take some time depending
on the current network load.
NAT Traversal Service User's Guide
][ ] to select "NAT
][ ], then press [Enter].
13