If These Messages Appear - Panasonic KX-VC500 User Manual

Additional Information

If These Messages Appear

Message
Call FAILED. Encryption
settings (On/Off) must match.
Please change the encryption
setting on one side and try
again.
Call Failed due to wrong
encryption password. Please
contact your installer.
Check the Main Camera
connection.
Unable to register, the contact
list is full.
Invalid IP Address.
Invalid Subnet mask.
Invalid Default Gateway.
Invalid Date/Time.
PC is not connected.
Check connection.
94 User Manual
•
The encryption settings do not match those of the other party in a video
conference call.
→
Change the encryption settings to match those of the other party.
(Page 64, Page 72)
•
The encryption password settings do not match those of the other party
in a video conference call.
→
Contact your dealer.
•
A cable or cord is not properly connected.
→
Check that all cables to the KX-VC500 are connected properly.
(Page 15)
•
The signal input from the main video camera is invalid.
→
A valid signal cannot be received from the connected main video
camera. Contact your dealer.
•
The contact list has reached its maximum capacity.
→
Delete unneeded contacts. (Page 59)
•
The format of the entered IP address is invalid.
→
Enter the IP address correctly, in the format XXX.XXX.XXX.XXX
(decimal values separated by periods). For values of only 1 or 2 digits,
enter these numbers as they are. Do not enter like [.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
Multicast or broadcast addresses cannot be used.
•
The input subnet mask is invalid.
→
Enter a valid subnet mask.
•
The input default gateway is invalid.
→
Enter a valid default gateway.
•
Enter a date within the valid parameters.
→
Enter a date between January 1, 2009, and December 31, 2035.
•
A cable or cord is not properly connected.
→
Check that all cables to the KX-VC500 are connected properly.
(Page 49)
•
The computer is not turned on.
→
Turn on the computer.
•
The computer is not set to output from its external monitor video out
port.
→
Change the computer's settings so that video is output from the external
monitor port.
Cause and Solution