Error Message In Embroidery Mode; Needle Thread Broken Or Empty; Check The Bobbin Thread; Sewing Foot Lifter - Pfaff creative 7570 Instruction Book

If the needle thread breaks or runs out the machine
stops after max. 6 stitches and elicits the message:
Attention: Needle thread is broken or
supply is empty
ok?
To resume embroidering at the position at which
the thread breakage occurred, press number key 9
and press the toot pedal. The machine now skips
back 6 stitches. You can repeat this procedure as
often as you wish. Then thread the needle thread
and and press the foot pedal. By pressing the ok
key the machine finishes embroidering the pattern
automatically.
The bobbin thread supply display blinks when the
bobbin thread is running low. The machine stops
and this message appears in the display:
Bobbin thread running low
ok?
You can continue sewing if you think that the
bobbin thread is sufficient for the rest of the
section, however the bobbin thread supply display
continues to blink. The display remains lit until a
full bobbin has been inserted and you continue to
sew.
• Sewing foot lifter
The sewing toot lifter must be brought to embro
idery position before beginning to embroider. If it is
not, the machine will not sew when you press the
foot pedal and the message appears:
Bring sewing foot lifter to
embroidering/darning position
ok?
• Lower feed dog
If the feed dog is not lowered for embroidering, the
machine does not embroider when the foot pedal
is pressed and the message appea rs:
Lower feed dog
ok?
The feed dog must be lowered in embroideri
mode.
Error messages in embroidery mode
• Needle thread broken or empty
•
Check the bobbin thread
I :
I
ii
I
I
I
29