I
I
I
j
I
j
j
j
I
I
I
I
R
Removing the presser foot
Switch off the master switch
Press the front part of the presser foot upwards and at the
same time the rear part downwards until it disengages from
the presser foot holder (30).
: 1
Attaching the presser foot
Place the presser foot under the presser foot holder (30), so
that when the presser foot lifter (51) is lowered, the pins of
the foot engage in the presser foot holder.
Setting the needle thread tension
Set the required amount of the needle thread tension (35)
using the markings on the tension dial.
The normal setting for sewing is 4
-
5. For decorative sewing,
darning and buttonhole sewing 3.
Check:
Please check that the presser foot is properly attached by
raising the presser foot lifter.
29
I