Smart Clone - Philips 22HFL4373D/10 Installation Manual

8. Smart Clone

Smart Clone
With Smart Clone it is possible to copy to/from a USB device TV the configuration data and channel list data. Place a
USB Memory stick in the USB side connector of the TV.
*The USB device should be formatted as FAT or FAT32.
[USB to TV]
1. Select [Smart Clone] and press OK.
2. Select [USB to TV] and press OK.
3. The clone data will be loaded from the USB device into the TV. To activate the loaded settings, wait until
the OSD message is displayed to remove the power cord.
4. Remove and re-insert the power cord.
[TV to USB]
1. Select [Smart Clone] and press OK.
2. Select [TV to USB] and press OK.
3. Clone data will be loaded from the TV into the USB device.
4. Wait until the OSD message returns to its earlier state before removing the USB device
Instant initial cloning: The process of instant initial cloning will be automatically triggered by a TV which is in virgin
mode. By inserting the USB key which contains the cloning data and power on the TV, the process will start, take
place and reboot the TV at the end. After the TV enters again in standby the USB drive can be removed.
!! Please check if all settings were properly cloned.
27