Table of Contents
Advertisement
7. Welcome Logo
There are 2 Philips logos displayed at startup. The second logo can be replaced by a picture uploaded via USB.
File format: 960 x 540 .jpg file. The Welcome Logo is displayed only when Standby mode is set to "Green".
Note: below timing values are approximate indications and can differ from the real situation!
How to upload Welcome Logo
1. Create a graphics file: 960 x 540 jpeg file with the logo.
2. File name must be: WelcomeLogo.jpg (File name is case-sensitive)
3. Save the file into the TV cloning data folder: Q555H/WelcomeLogo/WelcomeLogo.jpg
4. Insert the USB device into the TV
5. Enter the Professional menu
6. Go to the Smart Clone option and select USB to TV.(Make sure that Low Power standby is set on Green).
7. After restart, the TV should display the Welcome logo during startup.
Hotel Information
Any JPG file can be used for the Hotel information and can be triggered from the consumer menu screen.
How to upload single page Hotel Info
1. Create a JPG graphics file with maximum resolution 1920 x 1080.
2. File name: HotelInfo.jpg (File name is case-sensitive).
3. Copy the file to the "Wallpaper" folder inside the TV cloning data folder (Q555/Wallpaper/HotelInfo.jpg)
4. Insert the USB device into the TV
5. Enter the Professional menu
6. Go to Smart Clone
7. Select USB -> TV
8. Select "Display information"
9. Select "On" to enable Hotel Information
10. Store the settings before exiting the PBS setup menu.
26
Hide quick links:
Advertisement
Table of Contents
