Table of Contents
Advertisement
8. Welcome Logo
IMPORTANT: Total amount of size for SmartInfo and Welcome Logo MUST be smaller than 62 Mb (
There are 2 Philips logos displayed at startup. The second logo can be replaced by a picture uploaded via USB.
File format: 1280 x 720.png file. The welcome logo is display only if Low power standby is set to Green and TV is in
deep standby state before switching ON.
Note: Below the startup process is described. The switching time can be influenced by the low power standby,
features activated at startup and switch ON channel type (HD or SD).
How to upload Welcome Logo
1. Create graphics file: 1280 x 720.png with logo.
2. File name: TPN141HE_WelcomeLogo.png (File name is case-sensitive)
3. Save into the TV cloning data folder "TPN141HE_CloneData\MasterCloneData"
4. Insert USB device into TV
5. Enter [Professional settings] menu
6. Go to [Welcome logo] -> [USB -> TV]. This action will load the USB in to TV memory.
7. Go to [Display logo] and set the option [On] to enable Welcome Logo.
8. Go to main menu and select [Power Settings]
9. Press "HOME/MENU" button to save and exit. Select the option [Store and Restart now] and press
"OK". TV will store the settings and restart to apply the new settings.
7.1 SmartInfo
The SmartInfo feature can be used in two ways, as a picture slide show or as user interaction pages. The two ways of
using SmartInfo not complementary and cannot be used both at the same time. SmartInfo can display the pictures or
the webpages by pressing the "SmartInfo" button on the remote. To close SmartInfo any button on the remote can
be pressed. For both cases the pages are stored in TV memory can be change via USB flash drive or SmartInstall.
In the [Professional Settings] menus the options for SmartInfo are:
SmartInfo: OFF -> SmartInfo is not enabled.
SmartInfo: Show -> SmartInfo is configured as picture slide show
SmartInfo: Browser -> SmartInfo is configured to use webpages.
Note: Due the fact that EasySuite doesn't have a network interface, pages outside of TV memory
cannot be accessed.
All manuals and user guides at all-guides.com
[Low power Standby]: Set the value to Green.
megabyte
)
52
Advertisement
Table of Contents
