Refrigerator Installation; Unpacking; Location Requirements - KitchenAid KBRA22KMSS Use & Care Manual

REFRIGERATOR
INSTALLATION
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Removing packaging materials
• Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see the "Refrigerator Safety" section.
On some models, shelves, bins, door shelf rails, and other
feature parts may be packaged in the Interior FeaturePak.
Follow the instructions contained in the package for proper
assembly.
Depending on your model, to remove the protective
(transparent) film that is on the nameplate, which is located
on the freezer handle, use your fingernail and peel off the film,
starting from one side and peeling to the other.
IMPORTANT: Do not remove the white foam air return insert that
is located behind the control panel on the ceiling of the
refrigerator (on some models). The insert is part of the refrigerator
and not part of the packing material. If the insert is removed, ice
may migrate down from the freezer and cause icicles to form.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator
for cleaning or service, be sure to protect the floor.
Always pulI the refrigerator straight out when moving it.
Do not wiggle or "walk" the refrigerator when trying to move
it, as floor damage could occur.
E×plosion Hazard
Keep flammabJe materials and vapors, such as
gasoline, away from refrigerator.
FaiJure to do so can resutt in death, e×ptosion,
or fire.
• To ensure proper ventilation for your refrigerator, allow 1/2in.
(1.25 cm) space at the top and back and 3/16 in. (0.48 cm) on
each side of the refrigerator for ease of installation.
• If you are installing your refrigerator next to a fixed wall, leave
21/6in. (5.4 cm) minimum on each side (depending on your
model) to allow for the door to swing open.
v2"(1.25 crn}
i
_h,""(0.48era)
?
2%" {5°4 ern}
• If your refrigerator has an ice maker, make sure you leave
some extra space at the back for the water line connections.
NOTE: Do not install the refrigerator near an oven, radiator, or
other heat source, nor in a location where the temperature will fall
below 55°F (13°C).
Cleaning before use
After you remove all of the package materials, clean the inside of
your refrigerator before using it. See the cleaning instructions in
the "Refrigerator Care" section.
_mportant information to know about glass shemvee
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter
into many smal!, pebble-size pieces. This is normal. GIass
shelves and covers are heavy. Use special care when re-
moving them to avoid impact from dropping.