Advertisement
J
FEATURES
AND HOW TO USE THEM
CONTROL
PANEL
I
FAN CONTROL,.
This controls
fan operation
of the dehumidifier.
When
the humidistat
calls for dryer air, the com-
pressor
and fan motor
will run until the humidistat
setting
is satisfied_
Use HI for faster
air drying
and
LO for quieter
operation°
AUTOMATIC
SHUTOFE
The automatic
shutoff
switch
turns
off the dehu-
midifier
when
the water bucket
is filled to its preset
level
To restart
dehumidifier,
simply
remove
water
bucket,
empty
and rehang
it on the back of the unit°
HUMIDISTAT.
To adjust the humidistat
control
turn the knob
to
the setting
you prefer_
Constant.
If you choose
this setting,
dehumidifier
wilt run all
the time no matter
what the humidity
might
be.
! thru 6 plus Constant.
This is the range
of relative
humidity
on the humidi-
star control
knob_ "Youmay adjust
the humidistat
setting
higher
or lower to suit your needs°
Higher
numbers
make
air dryer;
lower numbers
leave more
moisture
in the air_ When
the relative
humidity
is
reduced
to the level you have chosen,
the dehumidi-
tier will turn itself off° It will turn itself on again
when
the humidity
rises
Off.
This setting
turns
the dehumidifier
off when
the
dehumidifier
is not needed
NOTE:
If you turn your dehumidifier
off and turn
it right on again,
the compressor
may try to start
then
stop.
This is normal.
In about two minutes,
the
compressor
will start again
and continue
to run_
SIGNAL
LIGHT.
The signal
light warns
when water
bucket
is full
for emptying
and the dehumidifier
has stopped
Be
sure to replace
bucket
properly
so unit will run°
DE-ICER
CONTROL,
Your Kenmore
dehumidifier
is equipped
with a
feature
to help you get the most
comfort
from your
new appliance
by permitting
it to operate
down to
55OE
If your dehumidifier
runs when
room temperature
and humidity
conditions
are low, frost can form on
its evaporator
coil. This interferes
with proper
operation.
The DE-ICER
control
senses
frost build-up
on the
evaporator
coil and automatically
shuts
off the com-
pressor.
The fan continues
to run, drawing
air across
the coil and melting
the frost. When
the coil is
defrosted,
the DE-ICER
control
restarts
the com-
pressor
automatically
and dehumidifying
is
resumed.
Before
installation,
allow the unit to warm
to
room
temperature
before
operating
It may not start
if temperature
is below 55°E
5
Advertisement
