Hotpoint RGA820 Owner's Manual & Installation Instructions page 28

Installation Instructions
[_LEVELING THE RANGE
A. Install the oven shelves in the oven and position the
range where it will be installed with front access to
front leveling legs and rear access to rear leveling
legs. All legs must be leveled BEFORE the product is
installed.
Lower
range
Leg _ _ ,_
lev_er _____.._,_._
range "_
Raise Lower
range -ange
Ion some models)
(on some models)
B. Check for levelnessby placing a spirit level or a cup,
partially filled with water, on one of the oven shelves.
If using a spirit level, take two readings-with the level
placed diagonally first in one direction and then the other.
C. Removethe drawer (on some models).Seethe Care and
cleaning of the range section. The front leveling legs can
be adjusted from the bottom and the rear legs can be
adjusted from the top (on some models) or the bottom.
D. Use an open-end or adjustable wrench to adjust the
leveling legs until the range is level.
I ,_ WARN I NG j Never completely remove
the leveling leg as the range will not be secured to the
anti-tip device properly.
E.After leveling the unit, slide it into final position and
verify levelness.
F. After the range is level, slide the range away from the
wall so that the Anti-Tip device can be installed.
PARTS INCLUDED
Anti-Tip Bracket Kit
28
[] INSTALLING THE ANTI-TIP DEVICE
AWARNING
ANTI-TIP DEVICE
. All ranges can tip.
. BURNSor other SERIOUSINJURIEScan
result.
. INSTALL end CHECK the enti-tip brecket
following the instructions supplied with
the bracket.
To reduce the risk of tipping the range, the range must be
secured by a properly installed anti-tip bracket. Follow the
instructions packaged with the bracket.
To check if the bracket is installed and engaged properly,
look underneath the range to see that the anti-tip arm
attached to the side panel is engaged in the bracket. On
some models,the storage drawer or kick panel can be
removed for easier inspection. If visual inspection is not
possible,slide the range forward, confirm the anti-tip bracket
is securely attached to the floor or wall, and slide the range
back so the anti-tip arm slidesjust under the anti-tip bracket.
If the range is pulled from the wall for any reason, always
repeat this procedure to verify the range is properly secured
by the anti-tip bracket.
If your range has no anti-tip bracket, call 1.800.626.8774 to
receive one at no cost.
WHEN ALL HOOKUPS ARE COMPLETED
Meke sure ell controls (]re left in the off position. Meke
sure the flow of combustion end ventilation air to the
range is unobstructed.
CONVERT TO LP GAS (or convert back to
natural gas from LP}
This range leaves the factory set for use with
natural gas. If you want to convert to LP gas, the
conversion must be performed by a qualified LP
gas installer.
The conversion instructions and LP orifices can be
found attached to the back of the range.
Keep these instructions and the orifices in case you
want to convert back to natural gas.