Table of Contents
Advertisement
Available languages
Available languages
IOUBLESHOOTING
GUIDE
.......................................................... "IGNITION
NOISE:
Black spots or horizontal streaks may appear, picture may flutter or drift.
Usually caused by interference
from automobile
ignition systems, neon
lamps, electrical drills and other electrical appliances.
"GHOSTS:
Ghosts are caused by the television signal folIowing two paths. One is the
direct path and the other is reflected from tail buildings, hills or some
other objects. Changing the direction or position of the antenna may
improve reception. Ghosting may also be caused by defects in the
antenna system such as unshieIded leads or connecting
several sets to
the same antenna without using multiple antenna coupIers.
Ghosting occurring when the plasma dispIay is connected to a cable TV
system may indicate a bad cable wire or loose connection.
Confirm that
the cable wire is properly connected.
,,SNOW:
If your receiver is located in the fringe area of a television station where
the signal is weak, your picture may be marred by the appearance
of
small dots. When the signal is extremeIy weak, it may be necessary to
..........
insta!I a special antenna to improve the picture.
Snowing occurring when the plasma display is connected to a cable TV
system may indicate a bad cable wire or loose connection.
Confirm that
the cable wire is properly connected.
Verticat stripes appear,
depending
on the screen
contents.
,,RADIO FREQUENCY
iNTERFERENCE:
The interference
produces moving ripples or diagonal streaks and in
some cases, causes loss of contrast in the picture.
,,PREVENTION
OF AN OBSTACLE TO RADIO RECEIVERS:
This monitor has been designed
pursuant to the FCC class B Rubs. This
is to prevent a problem to Radio receivers. If this monitor causes a
problem to Radio receivers, then take the following steps:
- Keep the monitor away from Radio.
°Adjust Radio antennas in order for the monitor not to receive
interference.
-The antenna cable of Radio should be kept away from the monitor.
- Use a coaxial cable for antenna.
You can check if this monitor influences Radio receivers by turning off all
other equipment
other than the monitor.
If you find a problem receiving Radio when using the monitor, check the
instructions
mentioned
above.
,,The plasma display panel is Iighting the phosphors
by the discharge of
internal radiation. Depending on the screen contents,
in rare cases this
may cause vertical stripes to appear because of failure to light. Please
note that this is not a malfunction.
|
Advertisement
Table of Contents
