FUNAI F42PDME Owner's Manual page 21

ATTACHING A WALL MOUNT BRACKET (SOLD SEPARATELY)
The following is a description of the method for attaching a wall mount to the plasma display.
When performing this operation, refer to the instruction manual included with the wall mount
kit.
_. CAUTION
• Any damage caused by incorrectly attempting to mount the plasma display is not covered under the
terms of the manufacturers warranty.
|
Plasma Display rear
Stand
1 Turn the plasma display over and place it
screen-first onto a table which has a soft cloth
draped over it.
Place the plasma display in a way so that the
stands hang over the edge of the table.
NOTE:
• Make sure to use a tame which can support the
weight of the plasma display and is larger than the
plasma display.
• Make sure the table is in a stable location.
2
Remove the stands from the plasma display.
Unscrew the M5 screws indicated by =_l_, and
remove the left and right stands.
NOTE:
• The screws and stands you have removed are
necessary for reattachment at a later date. Make
sure to keep them in a safe place.
3 Attach the left and right TV rails to the plasma
display using the M8 screws included with the
wall mount kit.
_2_indicates the position of the screw holes on
the plasma display
NOTE:
• Only use the screw holes indicated by (2_ for
mounting the plasma display.
• For instructions on how to attach the TV rails,
refer to the instruction manual included with the
mount wall kit.
Attach the plasma display to the wall.
NOTE:
• Refer to the instruction manual included with the
waft mount when securing the plasma display to
the waft.