Table of Contents
Advertisement
Available languages
Available languages
The procedure for selecting the input signal
described here is for use with the remote control.
However, the INPUT SELECT
button on the plas-
ma display can also be used in the same way.
Disp!aying the Current Input Signal
1 Press the DISPLAY button.
The name of the current input terminal
is dis-
played on the screen.
2 To clear the name of the current input terminal,
press the DISPLAY button again or wait for
approximately
4 seconds.
NOTE:
• Toredisplay the name of the input terminal, press
the DISPLAY button again.
Selecting
the Input Signal
1
Press the INPUT SELECT
button to select the
input signal.
Each time you switch the input signal, the
name of the selected input terminal is dis-
played on the display for approximately
4 sec-
onds.
The INPUT SELECT
button cycles through the
input terminals
in the following pattern:
[ Video1
I .1
Video2
_[
]_
(S-Video 1)/I
(S-Video 2)][
Component 1
/
{ Component2]-
NOTE:
• When switching the input signal, audio mute turns
ON temporarily,
• S-VIDE01
takes priority over the VIDEO 1 jack,
as does S-VIDEO 2 over the VIDEO 2jack.
Therefore, ff there is input to the VIDEO and S-
VIDEO terminals
at the same time, the S-VIDEO
signal is displayed
on the screen. If the S-VIDEO
cable is not connected
to the plasma display, the
VIDEO signal will be displayed
on the screen.
• 480i (interlaced)
signals can be connected
to the
COMPONENT
1 and 2 terminals. Any of the fol-
lowing display formats: 480i, 480p (progressive),
1080i and 720p (progressive)
signals can be con-
nected to the COMPONENT
2 terminal
If one of
these video signals is detected,
the format of the
input signal is displayed
after the name of the
current input terminal, as in the following manner.
• A "No signal" message
appears if there is no
video signal and there is no message
currently
displayed
on the screen for volume adjustment
or
the setup menu, etc. If there continues to be no
video signal for more than 10 seconds,
"No sig-
nal" slowly moves around the screen.
• If there is no video signal and there has been no
operation
from the remote control or the buttons
on the main unit for more than 15 minutes,
the
auto shut-off
function activates
and the display
switches to standby mode.
Advertisement
Table of Contents
