Advertisement
Available languages
Available languages
PROBLEM
Dishwasher
wilt not start
Dishwasher
will
not fill with water
Unusual noise
Dishwasher
leaks
CAUSED
BY
SOLUTI_ON
• Check house fuse or circuit breaker.
• Dishwasher
not
receiving electricity
• Dial not in correct
position for cycle
selected
,Turning the Dial
too far
• Turning the Dial
too far
-No water supply
• Water inlet valve
clogged
Improper loading
• Dishwasher
not
level
-Too much sudsing
• Spilled rinse agent
,Dishwasher
door
interferes with
surrounding
cabinets
-Make sure Dial is turned far enough and
cycle button is fully pushed ino
• Turn Dial to START.. Be careful you do not
turn the Dial any farther than necessary.
There is a delay between start-up and water
fill so you wilt not hear any wash action
right away.
• See the solution above.
• Make sure water supply valve under sink is
turned on.
• Water valve supply line may be clogged with
sediment. Clean out.
-Utensils may not be secure on rack pins.
or something
small may have dropped from
the rack° Water is causing
utensils to rattle.
Make sure everything
is securely placed
in dishwasher.
-Level dishwasher as described in Installation
Instructions. Don't place dishwasher on carpet.
, Improper detergent.
Use automatic
dishwasher
detergent
only or try a
different
brand or less detergent.
olf hand dishwashing
detergent
is used by
mistake, pour one measuring
cup of
vegetable oil in bottom of tub and run
dishwasher through a complete
NORMAL
WASH cycle with recommended
amount of
automatic
dishwashing
detergent.
*To remove suds from tub: Open dishwasher,
Let suds evaporate. Add 1 gallon of cold
water to tub. Close and latch dishwasher°
Pump out water by slowly turning Dial until a
drain period is reached. Repeat if necessary
• Spitled rinse agent can cause foam. during.
washing, This can lead to overflowing.
Wipe
UD
ot',r,
it4an÷cd
chill
of
rine_
aqent
_^Jifh
damp cloth.
• Make sure door does not touch cabinets
when opening or closing° Use levelling legs
to level dishwasher..
'I5
Advertisement
