Table of Contents
Advertisement
Replacing the oven light
The interior oven light bulb is located on the rear wall of the
oven and is covered with a glass shield held by a wire
holder.
Be sure the range is unplugged and all parts are COOLbefore
replacing oven light. Wear a leather-faced glove for protection
against possible broken glass,
To replace the interior
oven light bulb
1.
Turn electrical power off at the main source or unplug
the range.
2.
Open oven door for access to interior oven light. Once
located, press wire holder to one side to release the
glass shield (See Fig.l).
3.
Replace bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder
into place.
S.
Turn power back on again at the main source (or plug
the range back in).
6.
The clock wil! then need to be set with the correct time
of day. To reset, see "Setting the Clock" in this Use &
Care Guide.
Caution for aluminum
use on the cooktop
Aluminum Foil =Use of aluminum foil on a hot cooktop
can damage the cooktop. Do not use thin aluminum
cooking utensils or allow aluminum foil to touch the
surface elements under ANY circumstances.
Aluminum
utensils
-The melting point of aluminum
is much lower than that of other metals. Care must be
taken when aluminum pots or pans are used on the
cooktop. If aluminum pans are allowed to boil dry
when using the cooktop,
the utensil may be damaged
or destroyed.
glass shield
wire holder
Fig. 1
The glass shield and wire holder must be in place
whenever the oven is in use. This shield helps protect the
appliance bulb from high temperatures.
Advertisement
Table of Contents
