Exmark Lazer HP Operator's Manual page 41

5.1.20 Lubricate brake handle pivot:
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Lubricate bronze bushings on brake handle pivot with a spray type lubricant
or light oil.
5.1.21 Lubricate brake rod bushings:
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat up.
c) Lubricate bronze bushings on each end of brake rod shaft with a spray type
lubricant or a light oil (bushings are located to the inside of the flange bearings).
5.1.22 Lubricate motion control bronze bushings:
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat up.
c) Lubricate bronze bushings on flange bearings securing the motion control
arm shafts with a light oil or a spray type lubricant.
5.1.23 Check spark plugs:
a) Remove spark plugs, check condition and reset gaps, or replace with new
plugs. See Engine Owners Manual.
5.1.24 Change fuel filter:
a) A fuel filter is installed between the fuel tanks and the engine. Replace
when necessary.
NOTE: Use Kawasaki Part No. 49019-1055 for replacement filters.
5.1.25 Change hydraulic system filter:
NOTE: Use only Exmark Part No. 1-513211 for summer use above 32° F (0°C)
or Part No. 1-523541 for winter use below 32° F (0°C).
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Raise seat.
c) Carefully clean area around filter. It is important that no dirt or
contamination enter hydraulic system.
d) Unscrew filter to remove and allow oil to drain from reservoir.
IMPORTANT: Before reinstalling new filter, fill it with Mobil 1 15W-50 and
apply a thin coat of oil on the surface of the rubber seal.
Turn filter clockwise until rubber seal contacts the filter adapter, then tighten
the filter an additional 2/3 to 3/4 turn.
e) Fill reservoir as stated in Section 5.1.13.
f) Raise the rear of machine up and support with jack stands (or equivalent
support) just high enough to allow drive wheels to turn freely.
g) Start engine and move throttle control ahead to full throttle position. Move
the speed control levers to the full speed and run for several minutes. Shut
down machine and recheck oil level.
Service Interval: 160 hrs.
Service Interval: 160 hrs.
Service Interval: 160 hrs.
Service Interval: 160 hrs.
Service Interval: As Required
Service Interval: After First 250 hrs.
Then yearly thereafter
- 36 -