Exmark Lazer HP Operator's Manual page 33

5.1.4 Clean engine cooling system:
POTENTIAL HAZARD
♦ Excessive debris and damaged or missing rubber
baffles can cause the engine and hydraulic system to
overheat.
WHAT CAN HAPPEN
♦ Excessive debris around the engine cooling air intake
and inside of the pump drive belt compartment can
create a fire hazard.
HOW TO AVOID THE HAZARD
♦ Clean all debris from inside of pump drive belt
compartment daily.
a) Stop engine, wait for all moving parts to stop, and remove key.
) Clean all debris from inside of pump drive belt compartment.
b
c) Wipe debris from screen in engine cover. Rotate engine cover forward and
wipe debris from radiator core as required. Inspect seals in engine cover
and replace as necessary.
5.1.5 Clean grass build-up under deck.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Raise deck to the transport (5" (12.7 cm) cutting height) position. Lift the
front of unit and support unit using jack stands or equivalent support.
POTENTIAL HAZARD
♦ Raising the mower deck for service or maintenance
relying solely on mechanical or hydraulic jacks could
be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may not be enough
support or may malfunction allowing the unit to fall,
which could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or hydraulic jacks
for support. Use adequate jack stands or equivalent
support.
c) Clean out any grass build-up from underside of deck and in discharge chute.
5.1.6 Check mower blades.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Lift deck and secure in raised position as stated in Section 5.1.5.
Service Interval: Daily or more often in dry conditions
CAUTION
Information located:
•
•
Service Interval: Daily
CAUTION
Service Interval: Daily
- 28 -
On right fuel tank decal 103-4474.
On decal 1-633462 behind seat on
rubber heat shield flap