Kenmore 911.93508 Use & Care Manual page 26

CARE ANDCLEANING
RemovableParts (cont.)
CLEANING MATERIALS
= Dishwashing detergent
®Warm water
®Scouring pad or soap-filled
steel-wool pad
Bump
in
Rack
Raised Guide
Back of
the Rack
TO REMOVE
1. Pull the racks out to the stop
position.
2. Pull up the front of the rack and
slide under the bump of the rack
guide.
TO CLEAN
Clean with warm water and detergent.
For hard-to-remove stains, gently
scrub with a scouring pad or a
soap-filled steel-wool pad. Rinse well.
TO REPLACE
1. Place the raised back of the rack
onto the rack guides.
2. Lift the front of the rack until the
raised back slides under the bump
of the rack guides.
:3. Slide the rack all the way back.
TO REMOVE
1, Fully open the
door.
2, Push the hinge
locks down
toward the door
frame, to the
unlocked
position. This
may require a
flat-blade
screwdriver.
Hinge Lock
(Unlocked
Position)
Hin( Arm
3,
4,
5,
Firmly grasp both
sides of the door ,
at the top.
Close door to the
door removal
position.
Lift door up until
the hinge arm is
clear of the slot.
Removal Position
TO
1.
2,
REPLACE
Bottom Hinge
Firmly grasp both Edge of Arm
sides of the door Sic
at the top.
With the door at
the same angle
as the removal
position, seat the
indentation of the
hinge arm into
the bottom edge of
the hinge slot. Indentation
26