Kenmore 59666252400 Use & Care Manual page 15

m(E
(SOME MODELS)
Using Ice Maker for the First Time
1. Confirm ice bin is in
place and ice maker
arm is down.
2. After freezer section reaches
between 0° to 2° F (-18° to -17° C),
ice maker fills with water and begins
operating.
3. Allow approximately 24 hours after
installation to receive first harvest of
ice.
4. Discard ice created within first 12
hours of operation to verify system is
flushed of impurities.
Operating Instructions
1. Confirm ice bin is in place and ice
maker arm is down.
2. After freezer section reaches 0° to 2°
F (-18° to -17° C), ice maker fills with
water and begins operating. You will
have a complete harvest of ice
approximately every 3 hours.
3. Stop ice production
by raising ice maker
arm until click is
heard.
4. Ice maker will remain in the off
position until arm is pushed down.
ICE SERVICE RACK
(SOME MODELS)
To install and remove rack:
To install, slide
L-shaped
groove of shelf
down over back
wall screw.
Push rack back until screw is stopped
in L-shaped groove (1). Slide front
portion of shelf over front wall screw
(2).
To remove, perform above steps in
reverse order.
FIXED FREEZER SHELF
(SOME MODELS)
To remove and install shelves:
Remove shelf
by pulling out
to full
extension. Tilt
up front of I
shelf and pull straight out.
To install, insert shelf into refrigerator
liner rails and push to back of
compartment.
WIRE BASKET
(SOME MODELS)
To remove and install basket:
To remove
basket, pull
basket out
to full
extension.
Tilt up front of basket and pull straight
out.
> To install, insert basket into
refrigerator liner rails and push back
into place.
PULLOUT DRAWER
BASKETS
(SOME MODELS)
(Door assembly of drawer removed from
illustration for visual clarity.)
To remove baskets:
> Follow steps 1-3 of Pullout Drawer
(page 8).
To replace baskets:
> Follow steps 3-4 of Pullout Drawer
(page 9).
)0R STORAGE
DOOR SHELF
(SOME MODELS)
The Door Shelf provides convenient
storage for frozen food items in freezer
door.
To remove and install door shelf:
Tore o
lift assembly from
side liner tabs
and pull out.
> To install, fit ends
of shelf assembly on
liner tabs and slide down.
m
!-
15