Grounding Instructions; Conversion To Liquified Petroleum Gas (Or L - Kenmore 790.3669 Series Use & Care Manual

Grounding instructions
For personal safety, the cooktop must be properly grounded. For
maximum safety, the power cord must be plugged into an electrical
outlet that is correctly polarized and properly grounded.
DO NOT Operate the cooktop using a 2-prong adapter or an extension
cord. If a 2-prong wall receptacle is the only available outlet, it is the
personal responsibility of the consumer to have it replaced with a
properly grounded 3-prong wall receptacle installed by a qualified
electrician.
See the INSTALLATION INSTRUCTIONS packaged with this cooktop
for complete installation and grounding instructions.
Grounding type
(Do not, under an
wal{ receptacle circumstances,
cut, remove, or
bypass the
Power supply cord with
3-prong grounding plug
This appliance is equipped with a 3-prong grounding
plug for your protection against shock hazard and should be plugged
directly into a properly grounded receptacle. DO NOT cut or remove the
grounding prong from this plug.
Personal injury or death from electrical shock may
occur if the range is not installed by a qualified installer or
electrician.
_Avoid fire hazard or electrical shock.
DO NOT use an adapter plug, an extension cord, or
remove grou nding prong from electrical power cord.
Failure to follow this warning can cause serious
injury, fire or death.
Conversion to Liquefied Petroleum Gas (or L. P. Gas)
This natural gas range is designed to allow for conversion to Liquefied Petroleum (L. P.) Gas.
Only a qualified service agent should perform the L. P. conversion. Contact the local gas provider for conversion. A L. P.
Conversion Kit is supplied with this range and is located on the main back of the range. The kit contains installation
instructions which must be read before and followed carefully when installing the kit.
To avoid serious injury, any additions, changes or conversions required in order for this appliance to
satisfactorily meet the application needs must be made by a qualified service agent.
7