Setting Oven Controls - Kenmore 790.3669 Series Use & Care Manual

Setting Oven Controls
The CLOCK _') pad is used to set the clock. The clock may be set for 12 or 24 hour time
v
of day operation. The clock has been preset at the factory for the 12 hour operation. When
the range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash along with "PF" (power failure, See Figure 1).
When PF appears in the display and 12:00 is flashing, press @. No sound will be heard, but
after 10 seconds a beep will sound and PF will disappear.
INSTRUCTIONS
Figure 1
PRESS DISPLAY
To set the clock (e×ample: 1:30)
1. Press_-_.
"CLO" will appear in the display (Figure 2).
2. Press@@@padsto
set the time of day to 1:30 (Figure 3).
"CLO" will stay in the display. Press _. "CLO" will disappear
and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold@ for 6 seconds (Figure 3). CONTINUE holding
the pad until a beep is heard.
2. The displaywill show either"12Hr"(Figure4) or"24Hr"(Figure 5).
Flex
3. Press ¢_e,,toswitch between the 12 and 24 hour time of day display.
The display will show either "12Hr" (Figure 4) or "24Hr" (Figure 5).
to accept the desired change or press _ to reject
4. Press
thechange.
5. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
@
@@@
@
Figure 2
Figure 3
@ for 6 seconds
Figure 4
Clea_l,_j Figure 5
14