Kenmore 229.960330 Owner's Manual page 3

1. Read the Owner's Manual carefully Failure to fallow the
rules for safe operation and the instructions can cause
a malfunction of the boiler and result in death, serious
bodily injury, and/or property damage.
2. Check your local codes and utility requirements before
installation, The installation must be in accordance with
their directives,
3. Before servicing, allow boiler to cool. Always shut off any
electricity and gas to boiler when working on it. This will
prevent any electrical shocks or burns.
4. Never test for gas leaks with an open flame. Use soap
and check all connections. This will avoid any possibility
of fire or explosion.
5. Be certain your new boiler will be using the correct gas.
Overfiring will result in premature failure of the boiler
sections and cause dangerous operation.
6. Never vent this boiler into an enclosed space. Always vent
to the outside. Never vent to another room or inside a
building.
7. Be sure there is adequate air supply for complete
combustion.
8. Follow a regular service and maintenance schedule for
efficient and safe operation.
TOOLS
Pipe Wrench
Screwdrivers
Tin Snips
6 foot tape or folding rule
Hack Saw
LP Torch, if you have copper piping
Pipe cutter and threading tools
(for iron pipe systems)
MATERIALS
Pipe joint compound suitable for natural and propane gas.
Iron or copper pipe for the water lines,
Black pipe for the gas lines.
Miscellaneous fittings.
Solder and flux if you have copper piping.
The following booklets will help you in making the installation:
Electrical Wiring - Available at Sears from the Plumbing, Heating or Electrical Departments at nominal cost.
American National Standards, Installation of Gas Appliances and Gas Piping, ANSI Z223.1-1atest revision.
©btain from American Gas Association, 1515 Wilson Boulevard, Arlington (Roslyn), VA 22209
e07_3, _