Handle Assembly - Kenmore 1163072590C Owner's Manual

Y
HANDLEASSEMBLY
Before assembling your vacuumcleaner, be sure you
have all the parts shown on: page3.
WARNING
ElectricalShock Hazard
Do not plug into electricalsupply untilassemblyis
complete. Failureto do socould resultin electrical
shockor Injury.......
ii i i i i
/
Hand/e
Screw
Remove the handle screw located just below the top
edge of the back of the vacuum, (see illustration
above).
Position the handte so the cord hooks;are toward the
back of the cleaner,
lnsed" the handle
into the opening at
the top of the
vacuum,
Align the handle
screw in the hole in
the handle and the
handle screw hole
in the back of the
vacuum,
Insert thehandle
screw so it passes
through theback of
the vacuum into
the handle.
Begin to tighten the screw with your fingers. Itmay
be necessary to adjust the handle slightly.
........................... • •• , .............................................................. • ...........................