Table of Contents
Advertisement
Service and Adjustment
(cont'd)
Drain Valve Washer
Replacement
NOTE:
For replacement,
use a 17A2" x ly.,, x _" thick
washer
available
at your nearest hardware
store. For ordering
replace-
merit washers,
refer to the "Repair
Parts" section.
Turn "OFF" gas supply to water heater.
Follow "Draining" instructions.
Turning counter clockwise, remove the hex cap below the
screw handle.
Remove the washer and put the new one in place.
Screw the handle and cap assembly back into the drain valve
and retighten using a wrench. DO NOT OVER TIGHTENs,
Follow instructions
in the
Filling The Water
Heater
section.
Check for leaks.
Follow the lighting instructions
in the _Lighting _ section to
restart the water heater.
Housekeeping
Vacuum around base of water heater for dust, dirt, and lint on a
regular basis.
Combustible
materials such as dothing,
cleaning materials, or
flammable liquids, etc. must not be placed against or adjacent to
the water heater.
To insure sumcient ventilation and combustion air supply, prop-
er clearances from the water heater must be maintained
at all
times.
Service
Before calling for repair service, read the Start Up Conditions
and Operational
Conditions
found in the Troubleshooting
Guide of this manual.
If a condition persists or you are uncertain about the operation
of the water heater, let a qualified person check it out.
Contact SEARS Repair Services at 1-800-4-MY-HOME
(1-800-469-4663).
27
Advertisement
Table of Contents
