Venting; Wiring - Kenmore POWER MISER 153.35862 Owner's Manual

Installation Instructions (cont'd)
USE WITHOUT POWER CORD (cont'd)
3. A standard ½" conduit opening has been made in the water
heater junction box for the conduit connection.
4. Use wire nuts and connect the power supply wiring to the
w res inside the water heater's junction box.
5. The water heater must be electrically _grounded" by the
installer. A green ground screw has been provided on the
WIRING DIAGRAM
SW_A4,
_aj_ NO '
SWTT_
I_TO_ _ I_V
O
ater heaters _unctlon box. Connect ground wire to th s
location. For complete grounding details and all allowable
exceptions, refer to local codes or in the absence of local
codes, with the latest edition of the National Electrical Code,
ANSI/NFPA 70.
6. Replace the wiring junction cover using the screw
provided.
LtmT_
I
[_
_Lrmm.
[
[
p_ss_qE
Venting
AWARNING ]
To insureproper ventingof this gas-firedwater heater,the €or- ]
rect vent pipe diameter must be utilized. Any additions of]
other gas appliances on vent with this water heater will
adversely affectthe operation ofthe water heater.
The combu.stion and ventilat on a r flow must not be obstructed.
AWARNING
3" diameter
The vent pipe from the water heater must be I/4 nch per
PVC schedule 40 pipe and must slope upward
near foot.
All vent gases must be completely vented to the outdoors of the
structure (dwelling).
A WARNING [
The water heaterwith draft hoodinstalled mustbe properly [
ventedto a chimney whichterminates outdoor_Neveroper-I
atethe_ heat_"unle_it isvented tothe outdonrs andhasI
adequate a ir supply to avoid risks of improper operation, explo-
sion or asphyxiation. I
_i' WARNING
I
Ob_ructed o rdeteriorated ve_ systems may pr--_ent aserous I
healthrisk or asphyx_on.
I
15
AWARNING I
Failure to haverequi_l clearances between water heaterand
combustible mateHai w illresultn a timhazard.